Dual CV/ Gate to MIDI/ USB Interface Two independent CV/ Gate-to-MIDI/ USB interfaces, Each interface with 4 inputs (Gate, CVN, CVV, CVC), MIDI in/ out, USB, Euro rack format, Width: 10 HP, Depth: 55 mm, Power...
S-Trigger Cable With built-in S-trigger electronics, Length: 1.2 m, 3.5 mm Mono mini jack plug to 1/4" mono jack, Converts gate to switched trigger (S-trigger)'
External Foot Controller Module Foot controller connector and dual foot switch connector to provide analogue control voltages (foot controller) and two gate / trigger signals (footswitches) to control other A-100...
Gate / Trigger Combiner Simple, passive module that combines up to 7 gate, trigger or analog signals, Eurorack format, Width: 4 HP, Depth: 20 mm, Power Requirement: + 0mA (+ 12V) / -0mA (-12V)
USB/MIDI-CV/Gate Interface Allows the integration of the A-100 module system into a USB or MIDI system, 4 Analogue CVs, Gate signal, Width: 6 HP, Depth: 55 mm, Power consumption: + 12V: 60mA/ -12V: 10mA
Tapped BBD Module 6 Outputs (BBD stages 396, 662, 1194, 1726, 2790, 3328), Two mixing units each with dry/ wet knobs, Width: 30 HP, Depth: 70 mm, Power consumption: +120 mA (+12V) / -50 mA (-12V)
Cable Set For DIY Synthesizer kit, Consisting of two 16-pin and five 10-pin flat-ribbon cables, With matching counterparts to the 2-pin contact strips on the DIY Synth board, Length: Each 50 cm, The other end of each...
Filter 12 dB Multi-mode filter, in which the circuit of the SEM module is used, Width: 8HP 40.3 mm, Depth: 55 mm (measured from the rear of the front panel), Power requirements: +30 MA (+ 12V) / -20 mA (-12V)
Quad Exponential VCA / Mixer The module A-132-4 contains four identical voltage-controlled amplifiers (VCA) with exponential normalization. Each VCA has two control voltage inputs (CV1, CV2), a signal input (In), and a...